The Best Ways to Clean Hardwood Floors
-Prep your floor for cleaning by sweeping or dust-mopping to get rid of large particles of dirt and debris.
-Use a pH neutral cleaner that will be gentle on your hardwood floors.
-Use a fine spray mist to clean your floor in sections. Avoid putting too much liquid on your floors.
-Use a microfiber mop to clean. Traditional mops can work, but they can leave excess water on your floors.
-Skip using white vinegar and water to clean your floors. Using a specially formulated hardwood floor care cleaner is a smart way to maintain the beauty and look of your floors.
SOFTWOODS top 3
PINE: Pine is a softwood which grows in most areas of the Northern Hemisphere. There are more than 100 species worldwide.
Properties: Pine is a soft, white or pale yellow wood which is light weight, straight grained and lacks figure.It resists shrinking and swelling. Knotty pine is often used for decorative effect.
Uses: Pine is often used for country or provincial furniture. Pickled, whitened, painted and oil finishes are often used on this wood.
ASH: There are 16 species of ash which grow in the eastern United States. Of these, the white ash is the largest and most commercially important.
Properties: Ash is a hard, heavy, ring porous hardwood. It has a prominent grain that resembles oak, and a white to light brown colour. Ash can be differentiated from hickory (pecan) which it also resembles, by white dots in the darker summer wood which can be seen with the naked eye. Ash burls have a twisted, interwoven figure.
Uses: Ash is widely used for structural frames and steam bent furniture pieces. It is often less expensive than comparable hardwoods.
HICKORY: There are 15 species of hickory in the eastern United States, eight of which are commercially important.
Properties: Hickory is one of the heaviest and hardest woods available. Pecan is a species of hickory sometimes used in furniture. It has a close grain without much figure.
Uses: Wood from the hickory is used for structural parts, especially where strength and thinness are required. Decorative hickory veneers are also commonly used.
Oak is the most widely used hardwood. There are more than 60 species of oak, which can
be separated into two basic varieties; white and red. The red variety is also known as black oak (a reference to its bark).
Properties: Oak is a heavy, strong, light colored hardwood. It is ring porous, due to the fact that more and larger conductive vessels are laid down early in the summer, rather than later. Prominent rings and large pores give oak a course texture and prominent grain. Oak also has conspicuous medullary rays which can be seen as “flakes” in quarter sawed oak lumber.
Uses: Oak is the most popular wood used to craft American and English country designs. It is also used for Gothic and William & Mary reproductions, as well as many transitional and contemporary pieces.
Famous oak trees:
Minchenden (or Chandos) Oak
Seven Sisters Oak
The Crouch Oak
The Kaiser’s Oak
Even you would like to get the ideal offer on sanding process. Staining hardwoods is relatively simple, actually the toughest portion of the full procedure, choosing the right color or shade wood stain. Floor sanding process has been quite difficult several years before. Sanding the floor to eliminate gouges and scratches have turned into the most difficult portion of the process along with the worker really needs to be aware of nails that will protrude.
You can also cover the floor using a backpack vacuum to make certain there’s no dust and hair on the ground. Re-sanding prehistorical floors The floor that’s manufactured within the pre conventional time is extremely classic. Use the very first coat of the ground finish.
This issue could be sorted out in the event the clients can receive a design or perhaps a floor that is certainly nearly the same as the conventional selection. It’ll not be possible to get the appearance of floor following the newest days and nights. The procedure is designed even. Along with this, expect more costs within the floor prep time.
Additionally, labor costs are regional in nature as well as a lot the true expense of installing a hardwood floor will be contingent on a plethora of factors. An objection here is the cord would need to cross the floor generally. Make your decision depending on your floor condition.
Ask our agents here!
TOP 10 HARDEST WOODS:
1. Quebracho – From the Spanish “quebrar hacha,” which literally means
“axe breaker.” Aptly named, wood in the Schinopsis genus is among the
heaviest and hardest in the world.
2. Lignum Vitae -Widely accepted as the hardest wood in the world–this
wood has been listed as an endangered species and is listed in CITES.
Consider Verawood as a very close substitute.
3. Gidgee – This Australian endemic is both very heavy and very strong.
Some pieces are dark enough to be used as an ebony substitute: one that’s
even harder than the original article.
4. Snakewood – It’s easy to see what makes Snakewood so unique–its patterns
and markings resemble the skin of a snake. Limited supply and high demand
make this one of the most expensive woods on eart.
5. Verawood – Sometimes called Argentine Lignum Vitae, this wood is a gem:
inexpensive, great olive-green color, beautiful feathery grain pattern, and
it takes a great natural polish on the lathe.
6. Camelthorn – Formerly classified as a member of the Acacia genus, this
south African hardwood is a tough customer. The wood is stubbornly hard,
and the tree is protected by giant sharp thorns.
7. African Blackwood – In some parts of the world, this wood has achieved
an almost legendary status. Historical evidence points to this wood
(rather than Diospyros spp.) being the original “ebony.”
8. Black Ironwood – Pieces are very seldom seen for sale, as this tree is
too small to produce commercially viable lumber. Like the unrelated
Desert Ironwood, Black Ironwood is an excellent choice for small
9. Katalox / Wamara – Some pieces can be just about a dark as true ebony,
while others are a more reddish brown with black streaks. So much depth
in the Swartzia genus, there’s something for everyone!
10. Cebil- Also known as Curupay or by the exaggerated name Patagonian
Rosewood, Cebil is not a true rosewood. It has a highly variable streaked
appearance not too unlike Goncalo Alves.
How it works
We can give you a estimate over the phone or via email if you have the dimensions, as We work on a rate per sq meter or sq yard the estimate will allow for minor repairs,sanding and finishing with three coats of varnish.
If the price quoted seems reasonable, We will then visit your home to look at the floor and discuss your thoughts, concerns and ideas for the project.
We will then send you a written estimate or email you an estimate for the work.
If you would like to go ahead We will give you a date on which We will hope to start your room. We do not charge for my estimates or advice.
If you have a floor in need of some care and attention, please contact us for a no-obligation quote.